Crankshaft End Play, Check
- NOTE:
Crankshaft attached with crankshaft bearing caps.
Install the GE-571-B gauge (1).
- Install the holder on the front of the engine block.
- Place the dial gauge plunger against the crankshaft and adjust.
- Measure the longitudinal play of the crankshaft.
- Move the crankshaft in the longitudinal direction.
- Permissible crankshaft end play 0.100 - 0.202 mm (0.0039 - 0.0080 in).
- Remove the GE-571-B gauge.