Rear Seat Back Latch Release Handle Bezel Replacement

Fig 1: Rear Seat Back Latch Release Handle Bezel

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Rear Seat Back Cushion Latch Release Handle Bezel Cap Procedure Use a flat-bladed plastic trim tool to release the two bezel cap tabs.
2	Rear Seat Back Cushion Latch Release Handle Bezel Screw CAUTION: Refer to Fastener Caution . Tighten 2.5 N.m (22 lb in)
3	Rear Seat Back Cushion Latch Release Handle Bezel Procedure Pull the release handle to the open position so, the bezel can be removed. Using a flat-bladed plastic trim tool, start at the front of the bezel and gently insert trim tool to lift the bezel from the lower rear quarter panel.

Callout

Component Name

Rear Seat Back Cushion Latch Release Handle Bezel Cap
Procedure
Use a flat-bladed plastic trim tool to release the two bezel cap tabs.

Rear Seat Back Cushion Latch Release Handle Bezel Screw

CAUTION:

Tighten
2.5 N.m (22 lb in)

Rear Seat Back Cushion Latch Release Handle Bezel

Procedure

Pull the release handle to the open position so, the bezel can be removed.
Using a flat-bladed plastic trim tool, start at the front of the bezel and gently insert trim tool to lift the bezel from the lower rear quarter panel.