LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2017 >> Envision Base >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Controls And Fuel - 2.0L (LTG) Or 2.5L (LCV) - Repair Instructions >> Repair Instructions >> Charge Air Cooler Inlet Air Tube Replacement (LTG) >> Installation Procedure

Installation Procedure

    Fig 1: Charge Air Cooler Inlet Air Hose And Retainer Spring
    GM3923318Courtesy of GENERAL MOTORS COMPANY
  1. Clip in the retainer spring (1) and install the charge air cooler inlet air hose (2) to the charge air cooler.
    2. Fig 2: Charge Air Cooler Inlet Air Hose And Fasteners
    GM3923313Courtesy of GENERAL MOTORS COMPANY
  2. Install the charge air cooler inlet air hose (2) to the turbocharger.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the charge air cooler inlet air hose fasteners (1) and tighten to 22 N.m (16 lb ft).
  4. Install the front bumper fascia. Refer to Front Bumper Fascia Replacement .
scientia non olet · About LEMON Manuals