Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the fuel feed pipe (1).
- Connect the fuel feed pipe quick connection (3) to the fuel pump. Refer to Metal Collar Quick Connect Fitting Service .
- Install the fuel feed pipe bolt (2) to the cylinder head and tighten to 10 N.m (89 lb in).
- Remove the EN-6015 plug.
- Connect the fuel feed pipe quick connection (4). Refer to Metal Collar Quick Connect Fitting Service .
- Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
CAUTION:
Refer to Fastener Caution .