Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the evaporative emission canister (1) to the evaporative emission canister bracket (3).
- Remove the CH-807 plug from the evaporative emission canister purge pipe (4).
- Connect the evaporative emission canister purge pipe.
- Remove the CH-807 plug from the fuel tank vent pipe (2).
- Connect the fuel tank vent pipe.
- Raise the fuel tank to its original position.
- Pre-install the 4 fuel tank strap bolts (3, 5) with the fuel tank strap bolt retainers (2, 6) at the fuel tank straps (4).
- Mount the 2 fuel tank straps (4).
- Install the 4 fuel tank strap bolts (3, 5) and tighten to 20 N.m (15 lb ft).
- Remove the adjustable jack from the fuel tank.
- Clip the fuel feed pipe and the fuel vent pipe into the rear bracket clip at the underbody.
- Connect the fuel tank filler vent pipe (4). Refer to Plastic Collar Quick Connect Fitting Service .
- Install the fuel tank filler hose (3) to the fuel tank filler pipe (1).
- Install the clamp (2).
- Lower the vehicle.
NOTE:
A second technician is required.
CAUTION:
Refer to Fastener Caution .