LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Verano Premium, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 2.4L (Lea)) >> Repair Instructions - On Vehicle >> Oil Pan Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the oil level indicator tube. Refer to Oil Level Indicator Tube Replacement .
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the drive belt. Refer to Drive Belt Replacement .
  4. Drain the engine oil. Refer to Engine Oil and Oil Filter Replacement .
    5. Fig 1: A/C Compressor Bolts
    GM2538096Courtesy of GENERAL MOTORS COMPANY
  5. Loosen the 3 A/C compressor bolts (1, 2).
  6. Remove the A/C compressor bolt (2) completely.
    7. NOTE:

    Do not remove the A/C compressor.

  7. Pull the A/C compressor away from the engine block and oil pan in order to gain access to the oil pan.
    8. Fig 2: Transmission Bolts
    GM2538093Courtesy of GENERAL MOTORS COMPANY
  8. Remove the 4 transmission bolts (1) from the transmission.
    9. Fig 3: Oil Pan & Bolts
    GM2538097Courtesy of GENERAL MOTORS COMPANY
  9. Remove the long oil pan bolt (3).
  10. Remove the 14 short oil pan bolts (2).
    11. CAUTION:

    Pry the oil pan carefully in order to prevent damage to the transaxle case or the oil pan sealing surfaces.

  11. Remove the oil pan (1).
scientia non olet · About LEMON Manuals