Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the intake manifold (2) and the 4 NEW intake manifold gaskets (1).
- Install the 2 intake manifold nuts (4) and the 5 intake manifold bolts (4) to the intake manifold (2).
- Tighten the intake manifold nuts and the intake manifold bolts in sequence as shown to 25 N.m (18 lb ft).
- Install the fuel pump cover only to the fuel pump. Refer to Fuel Pump Replacement .
- Install the manifold absolute pressure sensor. Refer to Manifold Absolute Pressure Sensor Replacement .
- Install the intake manifold insulator. Refer to Intake Manifold Insulator Replacement .
CAUTION:
Refer to Fastener Caution .