LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Verano Premium, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 2.4L (Lea)) >> Repair Instructions - On Vehicle >> Intake Manifold Insulator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Intake Manifold Insulator
    GM2577138Courtesy of GENERAL MOTORS COMPANY
  1. Install the intake manifold insulator (1).
  2. Raise the vehicle.
  3. Pull the intake manifold insulator over the lower intake manifold brackets.
  4. Lower the vehicle.
    5. Fig 2: Intake Manifold Insulator & Components
    GM2757878Courtesy of GENERAL MOTORS COMPANY
  5. Install the brake booster vacuum pipe to the intake manifold stud and install the brake booster vacuum pipe clamp (6).
  6. Install the evaporative emission canister purge tube (3) to the intake manifold stud.
  7. Position the ECM wiring harness and clip in the ECM wiring harness clip (5) to the intake manifold.
  8. Connect the ECM wiring harness plug (4) to the manifold absolute pressure sensor.
    9. CAUTION:

    Refer to Fastener Caution .

  9. Install the fuel injector wiring harness plug bracket to the intake manifold and tighten the fuel injector wiring harness plug bracket bolt (1) to 10 N.m (89 lb in).
  10. Connect the ECM wiring harness plug (2) to the fuel injector wiring harness plug.
  11. Install the A/C compressor and condenser hose to the compressor. Refer to Air Conditioning Compressor and Condenser Hose Replacement (2.4L LEA) .
  12. Install the oil level indicator tube. Refer to Oil Level Indicator Tube Replacement .
  13. Install the brake booster vacuum pipe to the intake manifold.
  14. Clip the radiator surge inlet hose/pipe to the fuel rail.
  15. Install the throttle body assembly. Refer to Throttle Body Assembly Replacement .
  16. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  17. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals