Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Apply tension to the drive belt tensioner using the EN-44811 tensioner unloader by rotating counterclockwise and hold tension.
- Install the drive belt (1).
- Release tension from the drive belt tensioner and allow the tensioner to slide back slowly.
- Remove the EN-44811 tensioner unloader.
- Inspect the drive belt for proper seat.
- Install the front part of the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
- Install the front compartment insulator. Refer to Front Compartment Insulator Replacement .
- Lower the vehicle.