LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Verano Premium, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 2.4L (Lea)) >> Repair Instructions - On Vehicle >> Crankshaft Balancer Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the wheel - front right side. Refer to Tire and Wheel Removal and Installation .
  3. Remove front wheelhouse liner - right side. Refer to Front Wheelhouse Liner Replacement .
  4. Remove the front compartment splash shield. Refer to Front Compartment Splash Shield Replacement .
    5. Fig 1: Crankshaft Balancer Holder
    GM2538090Courtesy of GENERAL MOTORS COMPANY
  5. Use the EN-38122-A  holder (1) to counterhold the crankshaft.
    6. Fig 2: Crankshaft Balancer & Bolt
    GM2512759Courtesy of GENERAL MOTORS COMPANY
  6. Remove the crankshaft balancer bolt (2) while counter hold the crankshaft.
  7. Remove the crankshaft balancer (1).
scientia non olet · About LEMON Manuals