LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Verano Premium, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 2.4L (Lea)) >> Repair Instructions - On Vehicle >> Crankshaft Balancer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Crankshaft Balancer & Bolt
    GM2512759Courtesy of GENERAL MOTORS COMPANY
  1. Install the crankshaft balancer (1).
    2. Fig 2: Crankshaft Balancer Holder
    GM2538090Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install the crankshaft balancer bolt and tighten a first pass to 150 N.m (111 lb ft). Use the EN-38122-A  crankshaft balancer holder (1) to counterhold the crankshaft.
    3. CAUTION:

    Refer to Torque-to-Yield Fastener Caution .

  3. Tighten the crankshaft balancer bolt a final pass to an additional 100 degrees, using the EN-45059  meter. Use the EN-38122-A  crankshaft balancer holder (1) to counterhold the crankshaft.
  4. Install the engine splash shield - right side. Refer to Front Compartment Splash Shield Replacement .
  5. Install front wheelhouse liner - right side. Refer to Front Wheelhouse Liner Replacement .
  6. Install the wheel - front right side. Refer to Tire and Wheel Removal and Installation .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals