Camshaft Cover Replacement

WARNING: This page is about a different variant/trim than selected.

Fig 1: Camshaft Cover

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement . Remove evaporative emission canister tube. Refer to Evaporative Emission Canister Purge Tube Replacement . Disconnect the ECM wiring harness from the camshaft position actuator solenoid valves. Unclip the engine wiring harness and fuel line from the camshaft cover. Remove the 4 ignition coils. Refer to Ignition Coil Replacement .
1	Camshaft Cover Bolt (Qty: 11) CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Camshaft Cover
3	Camshaft Cover Gasket Procedure Use a NEW camshaft cover gasket.