LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Verano Premium, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 2.4L (Lea)) >> Repair Instructions - On Vehicle >> Automatic Transmission Flex Plate Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Re-cut the 8 automatic transmission flex plate bolt threads in the crankshaft.
    2. Fig 1: Automatic Flex Plate & Bolts
    GM2512742Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    CAUTION:

    Refer to Torque-to-Yield Fastener Caution .

  2. Install the 6 automatic flex plate (1) and 6 NEW automatic transmission flex plate bolts (2) handtighten.
  3. Tighten the automatic transmission flex plate bolts a first pass to 53 N.m (39 lb ft)
  4. Tighten the automatic transmission flex plate bolts a final pass to an additional 25 degrees, using the EN-45059  meter.
    5. Fig 2: Flywheel Holding Tool
    GM2512743Courtesy of GENERAL MOTORS COMPANY
  5. Remove the EN-43653  holding tool (1) from the starter assembly location.
  6. Install the automatic transmission. Refer to Transmission Replacement (2.4L LEA) .
scientia non olet · About LEMON Manuals