Valve Head O.D. and Chamfer Measurement Procedure
WARNING: This page is about a different variant/trim than selected.
- Measure the valve head O.D. and chamfer (a) using an appropriate scale. Refer to Engine Mechanical Specifications (LAF, LEA, or LUK) .
- If the valve head O.D. and chamfer is within specification, test the valve (1) for seat concentricity using the Valve-to-Seat Concentricity Measurement Procedure. Reinspect the valve head O.D. and chamfer after completing the concentricity measurement if valve seat reconditioning is performed.