Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P0685
The ECM detects that the commanded state of the driver and the actual state of the control circuit do not match for greater than 2 s.
P0686
The ECM detects a short to ground on the control circuit for greater than 2 s.
P0687
The ECM detects a short to voltage on the control circuit for greater than 2 s.
P0689
The engine controls ignition relay voltage is less than 5 volts for greater than 5 s.
P0690
The ECM detects the engine controls ignition relay feedback circuit is greater than 4 V for greater than 5 s.
P1682
The ECM detects that there is greater than 3 V difference between the ignition main relay signal and the engine controls ignition relay signal circuits for greater than 1 s.