LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Verano Premium, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Engine Mechanical - 2.0L (LHU) >> Repair Instructions - Off Vehicle >> Engine Block Assemble

Engine Block Assemble

    Fig 1: Locating Block Plugs
    GM2146311Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Apply sealant to all plugs prior to installation.

  1. Install the drain plug with sealant in the water pump. Refer to Adhesives, Fluids, Lubricants, and Sealers .
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the coolant jacket plugs with sealant and tighten to 35 N.m (26 lb ft).
    1. Install the rear oil passage plugs (3) with sealant and tighten to 60 N.m (44 lb ft).
    2. Install the other oil passage plugs (1, 2) with sealant and tighten to 35 N.m (26 lb ft).
    3. Fig 2: Oil Pressure Switch
    GM2591690Courtesy of GENERAL MOTORS COMPANY
  3. Lubricate the crankshaft position (CKP) sensor O-ring with clean engine oil. Refer to Adhesives, Fluids, Lubricants, and Sealers .
  4. Install the CKP sensor (1) and bolt and tighten to 10 N.m (89 lb in).
  5. Install the oil pressure switch (2) and tighten to 26 N.m (19 lb ft).
    6. Fig 3: Knock Sensors
    GM2146312Courtesy of GENERAL MOTORS COMPANY
  6. Install the knock sensors (1) and bolts and tighten to 25 N.m (18 lb ft).
    7. Fig 4: Piston Oil Nozzle Assembly
    GM2146314Courtesy of GENERAL MOTORS COMPANY
  7. Install the piston oil nozzle assemblies (1) and tighten to 15 N.m (11 lb ft).
scientia non olet · About LEMON Manuals