Conditions for Running the DTC

P0133

• DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0116, P0117, P0118, P0128, P0131, P0132, P0134, P0201, P0202, P0203, P0204, P0300, P0411, P0412, P0418, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0496 are not set.
• The engine coolant temperature (ECT) is hotter than 69°C (157°F).
• The system voltage is between 10-32 V.
• The fuel level is greater than 10 percent.
• The engine run time is greater than 60 s.
• The engine speed is between 1, 000-3, 500 RPM.
• The scan tool device controls are not active.
• The HO2S heaters have been on for more than 40 s.
• The learned HO2S heater resistance is valid.
• The intake air temperature (IAT) is greater than -40°C (-40°F).
• The fuel composition is less than 87 percent ethanol.
• The BARO pressure is greater than 70 kPa (10 psi).
• The fuel control is not in power enrichment.
• Decel fuel cut off is not active.
• The mass airflow (MAF) is between 10-50 g/s.
• The engine is in Closed Loop status.
• DTC P0133 runs once per drive cycle when the above conditions are met for 3 s.

P013A

• DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P013B, P013E, P013F, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0411, P0412, P0418, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271 are not set.
• The system voltage is between 10-32 V.
• The fuel level is greater than 10 percent.
• DTC P013E and P2270 have run and passed.

  THEN

• Decel fuel cut off is active.
• The accelerator pedal position (APP) is stable.
• This DTC runs once per trip.

P013B and P013F

• DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P013A, P013E, P013F, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0411, P0412, P0418, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271 are not set.
• The system voltage is between 10-32 V.
• The fuel level is greater than 10 percent.
• DTCs P013A, P013E, P013F, P2270, and P2271 have run and passed.
• DTCs P013B and P013F run once per trip.

P013E

• DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P013B, P013E, P013F, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0411, P0412, P0418, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271 are not set.
• The system voltage is between 10-32 V.
• The fuel level is greater than 10 percent.
• DTC P2270 has run and passed.

  THEN

• Decel fuel cut off is active.
• The accelerator pedal position (APP) is stable.
• This DTC runs once per trip.

P015A and P015B

• DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
• The ignition voltage is between 10-32 V.
• The engine coolant temperature (ECT) is greater than 70°C (158°F).
• The intake air temperature (IAT) is warmer than -40°C (-40°F)
• The HO2S heater is on for greater than 180 s.
• The fuel level is greater than 10 percent.
• The engine run time is greater than 120 s.
• The engine speed is between 1, 100-2, 300 RPM.
• The vehicle speed is between 51-120 kmh (31.7-74.6 mph).
• The engine airflow is between 3-12 g/s.
• Device controls are not active.
• The evaporative emission (EVAP) diagnostics are not in control of purge.
• The predicted catalytic converter temperature is between 600-900°C (1, 112-1, 652°F).
• The fuel system is in Closed Loop.
• The DTCs run once per drive cycle when the above conditions are met.

P2270

• DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P013A, P013B, P013E, P013F, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0411, P0412, P0418, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271 are not set.
• The system voltage is between 10-32 V.
• The fuel level is greater than 10 percent.
• The engine speed is between 1175-2200 RPM to enable and 1100-2300 RPM to keep enabled.
• The engine air flow is between 2-10 g/s.
• The vehicle speed is 65-119 km/h (41-74 mph) to enable and 56-132 km/h (35-82 mph) to keep enabled.
• The engine is in Closed Loop status.
• The Power Take-Off is not active.
• The HO2S heaters are on for more than 180 s.
• This DTC runs once per trip when all of the above conditions have been met for 3 s.

P2271

• DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P013A, P013B, P013E, P013F, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0411, P0412, P0418, P1174, P1516, P2101, P2119, P2135, P2176, P2270 are not set.
• The system voltage is between 10-32 V.
• The fuel level is greater than 10 percent.
• The engine speed is 1175-2200 RPM.
• The engine air flow is between 2-10 g/s.
• The vehicle speed is 65-119 km/h (41-74 mph).
• The engine is in Closed Loop status.
• Power take-off is not active.
• The HO2S heaters have been on more than 180 s.
• DTCs P013A, P013E, and P2270 have run and passed.

  THEN

• Decel fuel cut off is active.
• The APP is stable.
• This DTC runs once per trip when the above conditions are met.