Conditions for Running the DTC

P0089, P228C, or P228D

• DTC P0016, P0017, P0090, P0091, P0092, P0096, P0097, P0098, P00C8, P00C9, P00CA, P0111, P0112, P0113, P0116, P0117, P0118, P0128, P0178, P0179, P0192, P0193, P0335, P0336, P0340, P0341, P0365, P0366, P0628, P1682, P2269 is not set.
• The ignition voltage is greater than 11 V.
• The engine is running.
• The low side fuel pressure is greater than 250 kPa (36 psi).
• The intake air temperature (IAT) is greater than -10°C (14°F).
• The barometric pressure (BARO) is greater than 70 kPa.
• The fuel temperature is between -10°C and 100°C (14°F and 212°F).
• The DTCs run continuously when the above conditions are met for 60 s.

P00C6

• DTC P0016, P0017, P0090, P0091, P0092, P0096, P0097, P0098, P00C8, P00C9, P00CA, P0111, P0112, P0113, P0116, P0117, P0118, P0128, P0178, P0179, P0192, P0193, P0335, P0336, P0340, P0341, P0365, P0366, P0628, P1682, P2269 is not set.
• The ignition voltage is greater than 8 V.
• The engine coolant temperature is less than 65°C (149°F).
• The barometric pressure (BARO) is greater than 70 kPa.
• The intake air temperature (IAT) is greater than -10°C (14°F).
• The low side fuel pressure is greater than 300 kPa (44 psi).
• The diagnostic runs once for each engine start.