LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Verano Leather >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Controls And Fuel - 2.0L (LHU) - DTC P025A To DTC P2635 Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P05CC or P05CE: Cold Start Exhaust/Intake Camshaft Position System Performance >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition Off, disconnect the harness connector at the appropriate Q6 Camshaft Position Actuator Solenoid Valve.
  2. Test for 5-12 Ω between the ignition circuit terminal 1 and the control circuit terminal 2 of the Q6 Camshaft Position Actuator Solenoid Valve.
    • If not between the specified values 

      Replace the Q6 Camshaft Position Actuator Solenoid Valve.

    • If between the specified values 
  3. Test for infinite resistance between each terminal and the Q6 Camshaft Position Actuator Solenoid Valve housing.
    • If less than infinite resistance 

      Replace the Q6 Camshaft Position Actuator Solenoid Valve.

    • If infinite resistance 
  4. All OK.
scientia non olet · About LEMON Manuals