Second Clutch Applies

2-6 Pressure Control Solenoid 4 

The 2-6 pressure control solenoid 4 is commanded ON, allowing actuator feed limit fluid to enter the pressure control solenoid (PCS) 2-6 clutch fluid circuit. PCS 2-6 clutch fluid is then routed through orifice #32 to the 2-6 clutch regulator valve.

2-6 Clutch Regulator Valve 

PCS 2-6 clutch fluid moves the 2-6 clutch regulator valve assembly against the 2-6 clutch regulator valve spring force to allow 2-6 clutch/1-2-3-4 clutch feed fluid to pass through the valve. The 2-6 clutch/1-2-3-4 clutch feed fluid is routed into the 2-6 clutch fluid circuit where it passes through orifice #46 and then to the spring end of the 2-6 clutch regulator valve, and to the 2-6 clutch within the case cover.

2-6 Clutch 

The 2-6 clutch fluid from the 2-6 clutch regulator valve is routed through the case cover and to the 2-6 clutch piston assembly. The 2-6 clutch fluid pressure moves the piston against 2-6 clutch spring force to apply the 2-6 clutch plates.