LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 6T70 - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Transmission Rear Mount Replacement (FWD) >> Installation Procedure

Installation Procedure

    CAUTION:

    Refer to Fastener Caution .

  1. Install the transmission mount to transmission bolts and tighten to 100 N.m (74 lb ft).
    2. Fig 1: Transaxle Brace & Bolt
    GM2199343Courtesy of GENERAL MOTORS COMPANY
  2. Install the transaxle brace (3) with bolt (2) seated in the brace.
  3. Install the transaxle brace bolt (1) and tighten to 50 N.m (37 lb ft).
  4. Tighten the brace bolt (2) to 100 N.m (74 lb ft).
    5. Fig 2: Rear Transmission Mount Through Bolt
    GM2199347Courtesy of GENERAL MOTORS COMPANY
  5. Install the transmission mount to bracket through bolt (1) and tighten to 105 N.m (77 lb ft).
    6. Fig 3: Rear Mount To Frame Fasteners
    GM2199358Courtesy of GENERAL MOTORS COMPANY
  6. Install the rear mount to frame fasteners (1,2) and tighten to 100 N.m (74 lb ft) plus 120-130 degrees.
  7. Remove the jack stand.
  8. Install the left tire and wheel. Refer to Tire and Wheel Removal and Installation .
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals