LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 6T70 - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Control Solenoid Valve and Transmission Control Module Assembly Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Control Solenoid Valve Assembly Filter Plate
    GM1803492Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Use care when removing or installing the filter plate assembly. A broken or missing retaining tab may not adequately secure the filter plate to the control solenoid valve assembly, resulting in possible damage or contamination.

  1. Install a NEW control solenoid valve assembly filter plate (1).
    2. Fig 2: Identifying Control Valve Body Bolts Torque Sequence
    GM1803490Courtesy of GENERAL MOTORS COMPANY
  2. Install the control solenoid valve body and TCM assembly (5).
  3. Rotate the control solenoid valve spring (7) into position.
    4. CAUTION:

    Refer to Fastener Caution .

    NOTE:

    Install all bolts before tightening, then tighten in specified sequence.

  4. Install the 4 control valve body bolts (1) M6x80.
  5. Install the control valve body bolt (6) M6x55.
  6. Install the 3 control valve body bolts (2) M6x95.
  7. Install the control valve body bolt (3) M6x42.
  8. Install the 2 control valve body bolts (4) M6x65.
  9. Tighten all valve body bolts in specified sequence to 12 N.m (106 lb in).
    10. Fig 3: Identifying Electrical Connectors
    GM1803486Courtesy of GENERAL MOTORS COMPANY
  10. Connect the input speed sensor electrical connector (1).
  11. Connect the output speed sensor electrical connector (2).
  12. Connect the shift position switch electrical connector (3).
  13. Install the control valve body cover. Refer to Control Valve Body Cover Replacement .
  14. Program the module. Refer to Control Module References .
scientia non olet · About LEMON Manuals