Pump Assembly Installation
Pump Assembly Installation
| Callout | Component Name |
|---|---|
| 1 | Driven Sprocket Thrust Washer |
| 2 | Drive Sprocket Thrust Washer |
| 3 | Install Drive Link Assembly
NOTE:
Install as an assembly. |
| 4 | A/Trans Fluid Pump Assembly
NOTE:
Rotating the drive sprocket and link assembly while installing the oil pump will aid in aligning the driven sprocket and oil pump drive shaft splines. |
| 5 | A/Trans Fluid Pump Bolt M6x25 (Qty: 3)
CAUTION:
Refer to Fastener Caution . Procedure: Tighten in sequence shown. Tighten 12 N.m (106 lb in). |