LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 6T70 - Repair Instructions - Off Vehicle >> Repair Instructions - Off Vehicle >> Case Cover Assembly Disassemble >> Clean and Inspect

Clean and Inspect

Fig 1: Identifying Case Cover Assembly Components
GM1737959Courtesy of GENERAL MOTORS COMPANY
Clean and Inspect

Callout Component Name
CAUTION:

After cleaning the transmission components, allow to air dry. Do not use cloth or paper towels in order to dry any transmission components. Lint from the towels can cause component failure.

CAUTION:

Do not reuse cleaning solvents. Previously used solvents may deposit sediment which may damage the component.

Preliminary Procedures

  1. Thoroughly clean the case cover assembly, including threads, with clean solvent.
  2. Clean gasket sealing surfaces. Remove all residual gasket material.
  3. Inspect all threaded holes. If necessary, repair any thread damage.
1 Gasket Sealing Surface
2 Fluid Passages
3 Piston Bores
4 Cover to Case Passages
5 A/Trans Input Speed Sensor Assembly Bore
6 Cover Casting
7 Passage Cup Plugs
8 Input Shaft Support Bolts
CAUTION:

Refer to Fastener Caution .


Procedure 
Tightened bolts in sequence.
Tighten 
12 N.m (106 lb in).
scientia non olet · About LEMON Manuals