1-2-3-4 Clutch Plates and Low Reverse Clutch Installation
1-2-3-4 Clutch Plates and Low Reverse Clutch Installation
| Callout | Component Name |
|---|---|
| 1 | 1-2-3-4 Clutch (Waved) Plate
NOTE:
The tab on the clutch plate faces the bottom of the case. |
| 2 | 1-2-3-4 Clutch Plate (Qty:2)
NOTE:
The tab on the clutch plate faces the bottom of the case. |
| 3 | 1-2-3-4 Clutch (w/Friction Material) Plate Assembly (Qty:2) |
| 4 | Low and Reverse Clutch Assembly
NOTE:
The low and reverse clutch assembly should rotate freely in one direction and lock in the opposite direction. Rotate the clutch assembly and listen/feel for the ratchet of the clutch in it's designed rotational direction. |
| 5 | Low and Reverse Clutch Retaining Ring
NOTE:
The tab needs to go in groove at about 2 o'clock and snap ring opening needs to face 3 o'clock. |