Road Test: Notes

The following test provides a method of evaluating the condition of the automatic transmission. The test is structured so that most driving conditions would be achieved. The test is divided into the following parts:

• Electrical Function Check
• Upshift Control and Torque Converter Clutch (TCC) Apply
• Part Throttle Step In Downshifts
• Manual Downshifts
• Coasting Downshifts
• Manual Gear Range Selection
  • REVERSE
  • Driver Shift Control

Before the road test, ensure the following:

• The engine is performing properly.
• Transmission fluid level is correct. Refer to Transmission Fluid Level and Condition Check .
• Tire pressure is correct.

During the road test:

• Perform the test only when traffic conditions permit.
• Operate the vehicle in a controlled, safe manner.
• Observe all traffic regulations.
• View the scan tool data while conducting this test.

  Take along qualified help in order to operate the vehicle safely.

• Observe any unusual sounds or smells.

After the road test, check the following:

• Inspect for proper transmission fluid level. Refer to Transmission Fluid Level and Condition Check .
• Inspect for any diagnostic trouble codes (DTCs) that may have set during the testing. Refer to the applicable DTC.
• Monitor the scan tool data for any abnormal readings or data.
• Inspect for fluid leaks. Refer to Fluid Leak Diagnosis .