Circuit/System Verification
- Engine idling, transmission in Park, with parking brake applied and drive wheels chocked.
- Verify the transmission fluid level and condition is correct. Refer to Transmission Fluid Level and Condition Check .
- If the transmission fluid level and condition is not correct
Repair as necessary.
- If the transmission fluid level and condition is correct
- If the transmission fluid level and condition is not correct
- Ignition ON, clear the TCM DTCs with a scan tool.
- Verify DTC P2723 or P2724 does not set while performing a road test. Refer to Road Test .
- If DTC P2723 or P2724 sets
Refer to Circuit/System Testing.
- If DTC P2723 or P2724 does not set
- If DTC P2723 or P2724 sets
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame//Failure Records data.
- Verify the does not set.
- If the DTC sets
Refer to Circuit/System Testing.
- If the DTC does not set
- If the DTC sets
- All OK.
WARNING:
Refer to Parking Brake and Drive Wheels Warning .
NOTE:
If other DTCs are set, diagnose those DTCs first.