Circuit/System Description

The manual shift detent lever with shaft position switch assembly, or internal mode switch assembly, is a sliding contact switch attached to the manual shift detent lever within the transmission. The 4 inputs to the transmission control module (TCM), from the switch, indicate the position selected by the transmission manual shaft. The input voltage at the TCM is high when the switch is open and low when the switch is closed to ground. The state of each input is displayed on the scan tool as the internal mode switch A/B/C/P parameter. The internal mode switch input parameters represented are transmission range Signal A, Signal B, Signal C, and Signal P.

The park/neutral position switch is integrated into the transmission internal mode switch. The circuit uses the TCM as a pass-through connector only.

The park/neutral signal is sent from the park/neutral switch directly to the engine control module (ECM) and is used for engine start enable.