Circuit/System Verification
- Engine running, transmission in Park. Move the gear shift lever into each gear position and back into Park position.
- Verify the scan tool parameters listed below do not display Malfunction:
- Line Pressure Control Solenoid Valve Performance Test Status
- Line Pressure Control Solenoid Valve Control Circuit Low Voltage Test Status
- Line Pressure Control Solenoid Valve Control Circuit High Voltage Test Status
- If Malfunction is displayed
Refer to Circuit/System Testing.
- If Malfunction is not displayed
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing.
- If the DTC does not set
- If the DTC sets
- All OK.
WARNING:
Refer to Parking Brake and Drive Wheels Warning .