Circuit/System Verification
- Engine idling at the normal operating temperature, gear selector in the Park position, parking brake applied, and drive wheels chocked.
- Verify the transmission fluid level and condition is correct. Refer to Transmission Fluid Level and Condition Check .
- If the transmission fluid level and condition is not correct
Repair as necessary
- If the transmission fluid level and condition is correct
- If the transmission fluid level and condition is not correct
- From a stop, accelerate to 72 km/h (45 mph) with the scan tool Calculated Throttle Position greater than 15%. Perform this test 8 times.
- Verify DTC P0751 or P0752 did not set.
- If DTC P0751 or P0752 set
Refer to Circuit/System Testing.
- If DTC P0751 or P0752 did not set
- If DTC P0751 or P0752 set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing.
- If the DTC does not set
- If the DTC sets
- All OK.
NOTE:
If other DTCs are set, diagnose those DTCs first.