Final Inspection

Fig 1: Performing Final Inspection
Courtesy of GENERAL MOTORS COMPANY
1. After remounting and inflating the tire, check both beads, the repair and the valve with a water and soap solution in order to detect leaks.
2. If the tire continues to lose air, the tire must be demounted and reinspected.
3. Balance the tire and wheel assembly. Refer to Tire and Wheel Balancing .

For additional tire puncture repair information, contact:

Rubber Manufacturers Association (RMA)

1400 K Street, N.W., Suite 900

Washington

DC

20005-2403

Telephone: 202-682-4800

E-mail: informa.org

Website: www.rma.org