Fasten Safety Belt Indicators

There are 2 fasten safety belt indicators for this vehicle. The driver fasten safety belt reminder is monitored on the instrument cluster and the passenger fasten safety belt reminder is located in the hazard warning switch. The fasten safety belt indicators may only be ON during RUN.

The instrument cluster illuminates the driver fasten safety belt indicator under the following conditions:

• During the bulb check (will flash 20 times and then stay on solid until the driver seat belt is buckled).
• The inflatable restraint sensing and diagnostic module (SDM) sends the status of the driver seat belt to the instrument cluster via a serial data.

The hazard warning switch illuminates the passenger fasten safety belt indicator under the following conditions:

Passenger presence recognizes someone is sitting in the front passenger seat. The SDM controls passenger seat belt indicator in the hazard warning switch through a hard wire circuit. The passenger seat belt indicator will remain on until the passenger seat belt is buckled.