LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Repair Instructions >> Airbag Roof Side Rail Module Replacement - Left Side >> Installation Procedure

Installation Procedure

    Fig 1: Positioning And Aligning Inflatable Restraint Roof Side Rail Module
    GM2194141Courtesy of GENERAL MOTORS COMPANY
  1. Position and align the inflatable restraint roof side rail module on in the vehicle (1).
    2. Fig 2: Inflatable Restraint Roof Side Rail Module And Fasteners
    GM2194142Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    After ignition ON, the airbag system readiness indicator illuminates for 4 seconds and then goes out.

  2. Attach the airbag roof side rail module with new metal clip (1) to the bracket (2).
    3. CAUTION:

    Refer to Fastener Caution .

  3. Insert the airbag roof side rail module fastener (3) and tighten to 9.5 N.m (84 lb in).
  4. Connect the wiring harness plug (4).
  5. Install the 2 security clips (1). Then install the 4 fasteners (2) and tighten to 9.5 N.m (84 lb in).
  6. Install the headlining trim panel. Refer to Headlining Trim Panel Replacement (Without Sunroof) or Headlining Trim Panel Replacement (With Sunroof) .
  7. Install the windshield side garnish molding. Refer to Windshield Side Garnish Molding Replacement .
scientia non olet · About LEMON Manuals