Circuit/System Verification
- Perform the Actuator Recalibration (C67) procedure.
- Verify the concern or DTC has been corrected.
- If the concern or DTC has not been corrected
- Verify DTC B023A is not set.
- If DTC B023A is set
Refer to Circuit/System Testing - DTC B023A.
- If DTC B023A is not set
Refer to Circuit/System Testing - DTC B0223, B022A, B0233, B0408 or B0418.
- If DTC B023A is set
- If the concern or DTC has been corrected
- All OK.