Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON.
- Verify that each of the scan tool Hybrid Battery Cell Voltage 1-32 parameters are between 3.0-4.1 V and all parameters are within 0.1 V of each other.
- If any parameter is not between 3.0-4.1 V or is not within 0.1 V of the others
Refer to Circuit/System Testing.
- If all parameter are between 3.0-4.1 V and are within 0.1 V of each other
- If any parameter is not between 3.0-4.1 V or is not within 0.1 V of the others
- All OK.