Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Shift Lever And Selector Lever Cable Adjust Locks

Courtesy of GENERAL MOTORS COMPANY

NOTE:

When locking the adjuster locks (1) a defined snap noise should be audible/a snap effect should be felt.

Lock shift lever and selector lever cable adjust locks.
Lock shift lever and selector lever cable adjust locks (1), by pushing down the two blue locking pieces WITHOUT touching/preloading the fixed shift lever.
Install transmission control lever knob.
Turn the transmission control lever knob back 180 degrees.
Remove DT-527-A adjuster from transmission control housing.
Check correct shifting function.
If necessary repeat adjusting procedure.
Install the front floor console. Refer to Front Floor Console Replacement .