Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition ON.
Verify DTC P0651 is not set
- If DTC P0651 is set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If DTC P0651 is not set
Verify the scan tool CPP Sensor percent parameter varies from 0% when the clutch pedal is released, to 100% when the clutch pedal is in the apply position.
- If the percentage does not vary from 0% to 100%
  Refer to Circuit/System Testing.
- If the percentage varies from 0% to 100%
Operate the vehicle within the conditions for running the DTC to verify the DTC does not set. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- If the DTC sets
  Refer to Circuit/System Testing.
- If the DTC does not set
All OK.