Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0502
- DTC P0101, P0102, P0103, P0106, P0107, P0108, P0300, P0301, P0302, P0303, P0304, P0305, P0306, or P0503 is not set.
- Ignition voltage is between 9-32V.
- Accelerator pedal position is 8% or greater.
- Engine speed is 1,500-6,500 RPM.
- Engine torque is greater than 54 N.m (40 lb ft).
- DTC runs continuously when the above conditions are met.
P0503
- Ignition voltage is between 9-32V.
- Engine speed is between 200-7,500 RPM for 5s or greater.
- Transmission output shaft speed is at least 292 RPM for 5s.
- Transmission output shaft speed change is less than 124 RPM for 5s.
- DTC runs continuously when the above conditions are met.