LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission - 6T40 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Input Speed Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the control solenoid valve and transmission control module assembly. Refer to Control Solenoid Valve and Transmission Control Module Assembly Replacement .
    2. Fig 1: Identifying Speed Sensor & Shift Position Switch Electrical Connectors
    GM1998829Courtesy of GENERAL MOTORS COMPANY
  2. Disconnect the input speed sensor electrical connector (1).
    3. Fig 2: Identifying Input Speed Sensor Mounting Bolt
    GM1998841Courtesy of GENERAL MOTORS COMPANY
  3. Remove the input speed sensor bolt (2) M6x23.
  4. Remove the input speed sensor (3).
  5. Remove the 3 input speed sensor seals (1).
scientia non olet · About LEMON Manuals