LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission - 6T40 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Input Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Input Speed Sensor Mounting Bolt
    GM1998841Courtesy of GENERAL MOTORS COMPANY
  1. Install the 3 input speed sensor seals (1).
  2. Install the input speed sensor (3).
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the input speed sensor bolt (2) M6x23 and tighten to 9 N.m (80 lb in).
    4. Fig 2: Identifying Speed Sensor & Shift Position Switch Electrical Connectors
    GM1998829Courtesy of GENERAL MOTORS COMPANY
  4. Connect the input speed sensor electrical connector (1).
  5. Install the control solenoid valve and transmission control module assembly. Refer to Control Solenoid Valve and Transmission Control Module Assembly Replacement .
  6. Perform the service fast learn adapt procedure.
scientia non olet · About LEMON Manuals