Front Wheel Drive Shaft Seal Replacement - Right Side
WARNING: This page is about a different variant/trim than selected.
Courtesy of GENERAL MOTORS COMPANY
| Callout |
Component Name |
|
Preliminary Procedures
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle
.
- Remove the intermediate drive shaft. Refer to Front Wheel Drive Intermediate Shaft Replacement (with MR6)
|
| 1 |
Right Front Wheel Drive Shaft Oil Seal
NOTE:
- For seal removal use GE-6125-B
hammer with DT-23129
remover.
- For seal installation use GE-8092
handle with DT-47790
installer.
Special Tools
- DT-23129
Universal Seal Remover
- DT-47790
Seal Installer
- GE-6125-B
Slide Hammer
- GE-8092
Driver Handle
For equivalent regional tools, refer to Special Tools
. |