Auxiliary Fluid Pump Replacement (Hybrid)

WARNING: This page is about a different variant/trim than selected.

Fig 1: Auxiliary Fluid Pump

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Reposition the ECU and bracket. Set the park brake and chock the wheels. Disconnect the range selector cable from the range selector lever. Refer to Range Selector Lever Cable Replacement .
1	A/Trans Auxiliary Fluid Pump Seal
2	A/Trans Auxiliary Fluid Pump Gasket
3	A/Trans Auxiliary Fluid Pump Assembly
4	A/Trans Auxiliary Fluid Pump Outlet Bolt (Qty:2) CAUTION: Refer to Fastener Caution . Tighten 22 N.m (16 lb ft)
5	A/Trans Auxiliary Fluid Pump Bolt Tighten 22 N.m (16 lb ft)
6	Trans Auxiliary Fluid Pump Outlet Pipe Seal (Qty:2)
7	A/Trans Auxiliary Fluid Pump Outlet Pipe Procedure Fasten pipe to auxiliary pump and tighten bolt just enough to hold in place. Align pipe to case and tighten bolt just enough to hold in place.
8	A/Trans Auxiliary Fluid Pump Outlet Bolt (Qty:2) NOTE: Check the fluid. Tighten 22 N.m (16 lb ft)