Evaporative Emission Canister Purge Solenoid Valve Replacement

WARNING: This page is about a different variant/trim than selected.

Fig 1: Evaporative Emission Canister Purge Solenoid Valve

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement . Disconnect the evaporative emission pipes. Refer to Plastic Collar Quick Connect Fitting Service .
1	Evaporative Emission Canister Purge Solenoid Fastener CAUTION: Refer to Fastener Caution . Tighten 25 N.m (18 lb ft)
2	Evaporative Emission Canister Purge Solenoid Procedure Disconnect the electrical connector.

Callout

Component Name

Preliminary Procedures

Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
Disconnect the evaporative emission pipes. Refer to Plastic Collar Quick Connect Fitting Service .

Evaporative Emission Canister Purge Solenoid Fastener

CAUTION:

Tighten
25 N.m (18 lb ft)

Evaporative Emission Canister Purge Solenoid
Procedure
Disconnect the electrical connector.