Input Shaft Support Replacement (Gen 2)

WARNING: This page is about a different variant/trim than selected.

Fig 1: Input Shaft Support (Gen 2)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	3-5-Reverse and 4-5-6 Clutch Fluid Seals (Qty:3) NOTE: Discard the fluid seals. They are not reusable. Refer to 3-5-Reverse and 4-5-6 Clutch Fluid Seal Ring Replacement .
2	Input Shaft Support Bolts M6x50 (Qty:3) CAUTION: Refer to Fastener Caution . Tighten 12 N.m (106 lb in)
3	Input Shaft Support NOTE: Inspect the support for wear, damage or porosity.