Auxiliary Fluid Pump Installation (Hybrid)

WARNING: This page is about a different variant/trim than selected.

Fig 1: Auxiliary Fluid Pump

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	A/Trans Auxiliary Fluid Pump Seal
2	A/Trans Auxiliary Fluid Pump Gasket
3	A/Trans Auxiliary Fluid Pump Assembly
4	A/Trans Auxiliary Fluid Pump Outlet Bolt (Qty:2) CAUTION: Refer to Fastener Caution . Procedure Tighten in sequence shown. Tighten 22 N.m (16 lb ft)
5	A/Trans Auxiliary Fluid Pump Bolt Procedure Tighten in sequence shown. Tighten 22 N.m (16 lb ft)
6	Trans Auxiliary Fluid Pump Outlet Pipe Seal (Qty:2)
7	A/Trans Auxiliary Fluid Pump Outlet Pipe Procedure Fasten pipe to auxiliary pump and tighten bolt just enough to hold in place. Align pipe to case and tighten bolt just enough to hold in place.
8	A/Trans Auxiliary Fluid Pump Outlet Bolt (Qty:2) Tighten 22 N.m (16 lb ft)