Reluctor Wheel and Piston Installation
WARNING: This page is about a different variant/trim than selected.
Reluctor Wheel and Piston Installation
| Callout | Component Name |
|---|---|
| 1 | 3-5 Reverse Clutch Piston Dam Seal (Black) |
| 2 | 3-5 Reverse Clutch Piston Inner Seal |
| 3 | 3-5 Reverse Clutch Piston Inner (Reluctor) Seal (Orange) |
| 4 | 3-5 Reverse Clutch Piston Return Spring Assembly |
| 5 | 3-5 Reverse Clutch Piston |
| 6 | Input Shaft Speed Sensor Reluctor Wheel |
| 7 | Input Shaft Speed Sensor Reluctor Ring Retainer Ring
CAUTION:
Compress the reluctor wheel just enough to clear the retainer. Over compressing the reluctor wheel will break the alignment tab and the clutch housing.
CAUTION:
Regulate the air pressure to 276kPa (40psi) maximum. High pressure could cause the piston to over travel and damage the piston seals. Procedure Place the housing assembly onto the input shaft support inside the case. Apply shop air to the clutch fluid feed hole in the case to verify proper piston operation. Special Tools DT-47694 Piston Spring Compressor For equivalent regional tools, refer to Special Tools . |