Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0815 or P0816
- DTC P0815, P0816, P0826, P1761, P182E, P1876, P1877, or P1915 is not set.
- Engine speed is 400-7,500 RPM for 5s.
- Ignition voltage is 9-32V.
- Time since the last gear range change is 1s or greater.
- DTC runs continuously when the above conditions are met.
P0826
- DTC P0826 or P1761 is not set.
- Engine speed is 400-7,500 RPM for 5s.
- Ignition voltage is 9-32V.
- DTC runs continuously when the above conditions are met.