Circuit/System Description

When the shift lever is moved left of the D position, the transmission will enter sport mode. With the shift lever in this position, the transmission will enter manual mode if the gear shift lever is pressed forward or rearward. This allows the operator to select an upshift by pressing the gear shift lever forward, and downshift by pressing the gear shift lever rearward. The body control module (BCM) supplies an ignition circuit and a signal circuit to the shift controller. The shift controller has Hall-effect switches connected to a resistor array. When the lever is left of the D position, a voltage drop occurs across the resistor network. When the gear shift lever is pressed forward or rearward, a corresponding voltage drop occurs across the resistor network. This voltage drop is monitored by the BCM. The BCM will send the request to the transmission control module to perform the upshift or downshift. The TCM will not allow a downshift if the engine would be compromised by overspeeding.