Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0796
- DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0401, P042E, P0716, P0717, P0722, P0723, or P182E is not set.
- Engine speed is 400-7,500 RPM for 5s.
- Transmission output speed is 100 RPM or greater or the throttle position is 0.5% or greater.
- Ignition voltage is 9-32V.
- Transmission fluid temperature is -6.7°C (20°F) or greater.
- High side driver is enabled.
- Throttle position signal is valid.
P0797
- DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0401, P042E, P0716, P0717, P0722, P0723, or P182E is not set.
- Engine speed is 400-7,500 RPM for 5s.
- Transmission output speed is 100 RPM or greater or the throttle position is 0.5% or greater.
- Throttle position signal is valid.
- Ignition voltage is 9-32V.
- Transmission fluid temperature is -6.7°C (20°F) or greater.
- High side driver is enabled.
- The throttle position is 10% or greater and the engine torque is 45 N.m (33 lb ft) or greater if attained gear is 1st free wheel.
- DTC runs continuously during shift when the 4-5-6 clutch is commanded OFF, until commanded range is attained.