Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0401, P042E, P0716, P0717, P0722, P0723, or P182E is not set.
Transmission fluid temperature is -6.6°C (-20°F) or greater.
Engine speed is 400-7,500 RPM for 5s.
Output shaft speed is 100 RPM or greater or the throttle is 0.5% or greater.
Ignition voltage is 9-32V.
Shift is complete.
Engine torque signal is valid.
Throttle position signal is valid.
High-Side driver is enabled.
DTC runs continuously when above conditions are met.